![realtek network driver windows 10 only 10 mbps realtek network driver windows 10 only 10 mbps](https://thegeekpage.com/wp-content/uploads/2018/08/100-mbps-half-duplex.jpg)
- #Realtek network driver windows 10 only 10 mbps full
- #Realtek network driver windows 10 only 10 mbps software
- #Realtek network driver windows 10 only 10 mbps mac
When users change the setting to Re-Link and user unplugs and plugs network cable again, the driver will automatically disable gigabit capability. What is Auto Disable Gigabit ? Why have this feature ? Who requires to use this feature?Ī. Re-Link, Battery or AC : auto disabled gigabit when re-link.Re-Link, Battery : auto disabled gigabit when re-link and using battery.This affects shutdown mode (S5) power consumption. What is Shutdown Wake-On-Lan ? Why have this feature ? Who requires to use this feature?Ī. Disabled : PHY turn off to reduce power consumption but could not wakeup by magic packet.Enabled : system could wakeup from shutdown by magic packet.If responses successfully, the jumboframe works.Ping a large packet to the other machine.To avoid switch/hub compatiblity issue, please connect the two NICs directly.If two sides has different jumboframe length limitation, use smaller value.įor example, cardbus 8169 and PCI 8169 should use 3KB. Both sides enable the jumboframe to a identical value.If exceeds, driver automatically decreases the length to a proper value. Driver will not enable the option which exceeds the NIC hardware limitation. If users enable both of them, the driver automatically chooses Jumbo Packet.įor switch compatibility and TCP/IP performance, it is better to use Large Send Offload (IPv4) rather than Jumbo frameĪlthough, the Advanced page has Disable, 2KB MTU, 3KB MTU. Users may directly link the 2 machines to avoid the maximum length limitation but this also limit the connectivity.ĭriver will disable Large Send Offload (IPv4) after user enables this feature, TCP/IP could has better performance if it use jumbo frame without large send. If the ethernet switch could not support the jumbo frame, the packet will be discarded. It is out of ethernet specific and has ethernet switch/hub compatibility. It increases the maximum length of one packet.
![realtek network driver windows 10 only 10 mbps realtek network driver windows 10 only 10 mbps](https://www.linksys.com/support/images/KB945-009_EN_v2.png)
![realtek network driver windows 10 only 10 mbps realtek network driver windows 10 only 10 mbps](https://ish7anli.com/wp-content/uploads/2020/02/51Q2rsh8FBL._SL1000_.jpg)
What is Jumbo Frame What is the purpose of this featureĪ. This reduces CPU utilization and improve throughput. The interrupts are automatically trigger in a period.
#Realtek network driver windows 10 only 10 mbps software
Disabled : OS use software routine to calculate checksum.Rx Enabled : OS only offloads RX packets to hardware.Tx Enabled : OS only offloads TX packets to hardware.Rx & Tx Enabled : Both RX and TX are enabled.
![realtek network driver windows 10 only 10 mbps realtek network driver windows 10 only 10 mbps](https://i-tec.pro/wp-content/uploads/kompatibilita-6.jpg)
OS offloads IPv4 checksum calculation to hardware.
#Realtek network driver windows 10 only 10 mbps mac
If so, the driver stops to load after the wrong MAC address changed. Please do not use broadcast or multicast address.